Calculate the wall thickness, inside diameter and weight of PE100 and PE80 polyethylene (HDPE) pipes according to EN 12201-2 / ISO 4427. Choose the outside diameter and SDR / pressure class, enter length and quantity, and compare all sizes in the technical table below.

Quick Calculation — Wall Thickness & Weight

Wall thickness (s)–
Inside diameter (di)–
Weight per metre–
Weight of 1 pipe–
Total weight–

Technical Table PE100

Click any value in the table to load it into the calculator.

DN = Outside diameter (mm) · s = Minimum wall thickness (mm) · s* = Wall thickness tolerance (mm, +) · kg/m = Weight per metre · SDR = Standard dimension ratio (DN / s) · Density = 0.955 g/cm³ · Weight is calculated with the mean wall thickness (s + s*/2). Theoretical values per EN 12201-2 / ISO 4427; actual values may vary with manufacturing tolerances.

Calculation Formulas

  • Wall thickness: s = DN / SDR (using exact ISO 4065 S-series values; rounded up to 0.1 mm, minimum 2.0 mm)
  • Tolerance: s* = 0.1 × s + 0.1 (rounded up to 0.1 mm)
  • Inside diameter: di = DN − 2 × s
  • Weight per metre: M = π × smean × (DN − smean) × ρ / 1000
  • Pressure class: PN = 20 × σ / (SDR − 1) — PE100: σ = 8.0 MPa, PE80: σ = 6.3 MPa

What Are SDR and PN?

SDR (Standard Dimension Ratio) is the ratio of outside diameter to wall thickness; a lower SDR means a thicker wall and higher pressure capacity. PN is the maximum operating pressure (bar) for water at 20 °C. At the same SDR, PE100 pipe has a higher pressure class than PE80.

Why Wall Thickness Matters in Welding

In butt fusion, heating, changeover and cooling times and welding pressure depend directly on wall thickness. The correct pipe dimension is the first step in choosing a butt fusion or electrofusion machine. Contact us for your project.